View Single Post
MrRonFL's Avatar
Forum Topic Moderator

Join Date: Jun 2000
Posts: 15,311
FL

02-18-09, 10:16 AM   #17 (permalink)  
Do you have the installer manual?

You say that you have a Vista 10se. The command to go to program mode for a Vista 10se is [installer code] + 8 + 0.

The keystrokes to program a new master code:

Starting in normal run mode, NOT program mode.

[installer code] + 8 + 2 + [new master code]
(this must be one smooth set of keystrokes, if you hesitate more than a second or two between keystrokes the system will exit code programming).

All of this stuff is either in the user manual, or in the installer manual, both of which you should have before attempting this.


"Ask the Right Question..."
- from _The Snow Queen_ by Joan D. Vinge-