Gentechx13
#1
Member
Thread Starter
Join Date: Sep 2019
Location: United States
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Gentechx13
I have a squirrel cage with a gentech x13 motor. Can you bypass the control module? I'm wanting to use it as a shop fan
#2
Welcome to the forums.
Probably not the best choice of motors for a basic shop blower. You need to supply the proper power to the terminals on the side of the motor. You also need to apply 24vAC from common to one of the speed/torque terminals. The video below illustrates the wiring necessary to get it to run.
X-13 wiring
Probably not the best choice of motors for a basic shop blower. You need to supply the proper power to the terminals on the side of the motor. You also need to apply 24vAC from common to one of the speed/torque terminals. The video below illustrates the wiring necessary to get it to run.
X-13 wiring