I have a central AC system where the inside air handler is a BRYANT Model FVACNF002 and the outside compressor is a BRYANT Model 116BNA030-A. I need to know the filter size for the inside handler cabinet. I did a search on Bryant's web site and found this PDF file: [url]https://www.utcccs-cdn.com/hvac/docs/1009/Public/03/PDSFV4C-05.pdf[/url] this is a manual for FVAC 002 through 006 so I am not sure if this is the right one for my unit, plus the "NF" in the middle of the model number is not referenced. Anyway on page 3 is the only place I found a reference as below under "002"column. Does it mean the filter size is 16-3/8" X 21-1/2" X 3/4" ? If not anyone know what size it should be using? Will this be nominal or actual? I assume subtract 1/2" if it's nominal?

My Lennox gave it up and will not start. The run capacitor is clearly bad. It is very badly domed and I can't get any reading with my meter for either HERM or Fan. So I ordered a GE Gentec 70 mfd 10 mfd 370VAC to replace a CDC 70 mfd 10 mfd 370VAC , but now I note one difference. The one being replaced is +/- 10% and the replacement is rated +8 for the 70 and -8% for the Fan. I think. It is hard reading that part of the label in the photo on the web. I am guessing that is just a printing mistake and it should have been marked +8-8%. [url]https://www.amazon.com/Genteq-Round-Capacitor-27L414BZ3-27L414/dp/B00BY9JEIK/ref=sr_1_12?gclid=CjwKCAjw3c_tBRA4EiwAICs8CvnZw9IzkJYprb6udeq3uta3MlaLIB-2RcymbkMAJseZD18N1ItlwRoCNwMQAvD_BwE&hvadid=380224757224&hvdev=c&hvlocphy=9031527&hvnetw=g&hvpos=1o2&hvqmt=b&hvrand=14618665792822581549&hvtargid=aud-676677759484%3Akwd-303578762558&hydadcr=2795_9781138&keywords=capacitor+70+10&qid=1572307324&sr=8-12[/url] Anyway, my question is should I install it and if it works go with it? It isn't due to be delivered for a couple of days.