Handlebar adjustment
#1
#3
I believe that the allen wrench is a 6 mm. Loosen it and then tap it downward to loosen the bars in the head tube/head set assembly.
Be careful not to loosen it too far or the wedge will fall off the end of the bolt.
Raise it to the appropriate height and do not raise it above the suggested height marking. The message says something like "Caution: do raise above this line"
More than a Carpenter
http://www.carpenter.cjb.net
Be careful not to loosen it too far or the wedge will fall off the end of the bolt.
Raise it to the appropriate height and do not raise it above the suggested height marking. The message says something like "Caution: do raise above this line"
More than a Carpenter
http://www.carpenter.cjb.net