ZONE VALVE Problem
#1
ZONE VALVE Problem
Taco zone valve 555-102
My heat won't start unless I move the lever down a little bit then it runs all day then I have to do it again.
What is going on here????
Can anyone help me?
My heat won't start unless I move the lever down a little bit then it runs all day then I have to do it again.
What is going on here????
Can anyone help me?
#3
I have two and yes this is the only one with a problem, I checked the wireing, and redid it so if there was a small break. If I put it manual, pull it down just a little it works. I did an oma test all is good. WHAT is the problem? Please can anyone help me with this???
#6
Thank you all for all your help on this matter, found the problem....Redid all the wireing all works good now, must have had a broken wire...
#7
Taco Zone valve
I have two taco zone valves. One has been acting up. I did find a broken wire. Is it right if when I checked to see if valve was working that the little arm goes down a bit? I always thought that it stays in one place up, and its the inside that moves???
Should I change this with the other one that seems to be working good, and if so to change I wait til it goes off then just remove???
Should I change this with the other one that seems to be working good, and if so to change I wait til it goes off then just remove???