Paver going--pattern question
#1
Member
Thread Starter
Join Date: Apr 2006
Location: US
Posts: 76
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Paver going--pattern question
So far so good, we're putting in our pavers now (4 X 6 Holland bricks) and have a queston:
Our walkway shape is basically "L" shaped with the shorter end going up to the house and the longer end running along the house. Rather than try for a 90 degree turn we went with a curved or gradual turn.
Does anyone have any tips on adapting a herringbone pattern so that it works (without tons of cuts) in a curving installation?
Thanks
Our walkway shape is basically "L" shaped with the shorter end going up to the house and the longer end running along the house. Rather than try for a 90 degree turn we went with a curved or gradual turn.
Does anyone have any tips on adapting a herringbone pattern so that it works (without tons of cuts) in a curving installation?
Thanks
#2
Herringbone pattern
With a herringbone pattern, you will always have cuts. The good thing is that is the strongest and most stable pattern.
You can use either a hand splitter and split as and where you lay them or you can set up a saw and saw them. Most people get unnessarily worried about not having a smooth edge towardsaw them, but that is not a problem. You cut the pieces out of the other cut portion or a fresh paver. Because you have a curve there will be little repetition in the curved section.
I have seen many contractors use a gas power saw and saw off the excess beyond a marked line. This method is good for odd shaped paver shapes and complex patterns. The edging is then put in, sand spread the the surface compacted ans swept.
Dick
You can use either a hand splitter and split as and where you lay them or you can set up a saw and saw them. Most people get unnessarily worried about not having a smooth edge towardsaw them, but that is not a problem. You cut the pieces out of the other cut portion or a fresh paver. Because you have a curve there will be little repetition in the curved section.
I have seen many contractors use a gas power saw and saw off the excess beyond a marked line. This method is good for odd shaped paver shapes and complex patterns. The edging is then put in, sand spread the the surface compacted ans swept.
Dick