Go Back

DoItYourself.com Community Forums > Exterior Improvement Center > Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete

Reload this Page

>

Patio Door Steps - Need some ideas

Patio Door Steps - Need some ideas

Closed Thread

Search this Thread

#1

Old

10-04-09, 10:44 AM

N

navarc01

navarc01 is offline

Member

Thread Starter

Join Date: Oct 2009

Location: San Diego, CA

Posts: 2

Upvotes: 0

Received 0 Upvotes on 0 Posts

Cool

Patio Door Steps - Need some ideas

I've been trying to figure out how to best construct steps (wood or concrete) for my back patio.

Last edited by navarc01; 10-04-09 at 10:52 AM. Reason: Trying to copy picture - Right Click on URL icon to open photo

Upvote

#2

Old

10-07-09, 05:12 AM

Z

Zooman3

Zooman3 is offline

Member

Join Date: Oct 2009

Location: Ill.

Posts: 4

Upvotes: 0

Received 0 Upvotes on 0 Posts

Are going from turf to patio or from house to patio? Need more info before providing some solutions.

Upvote

#3

Old

10-07-09, 09:05 AM

F

fxpose

fxpose is offline

Member

Join Date: Sep 2009

Location: near Dodger Stadium

Posts: 70

Upvotes: 0

Received 0 Upvotes on 0 Posts

Also, a photo may be helpful.

Upvote

#4

Old

10-07-09, 09:27 AM

Gunguy45

Gunguy45 is offline

Super Moderator

Join Date: Dec 2007

Location: USA

Posts: 19,281

Received 6 Upvotes on 6 Posts

http://forum.doityourself.com/electr...your-post.html

This explains how to insert a pic....

Upvote

Thread Tools

Search this Thread

Show Printable Version

Show Printable Version

Email this Page

Email this Page

Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete
Drylock Hydrolic Cement and Massonary Repair verse other providers?

G

GreenJelly on Oct 06, 2009

There are a few providers of products to repair Masonry damage and concrete damage in basements. Some of these products are easier to use and are cheaper in larger quantity. Specifically I am looking at multiple tubes of [url=http://www.ugl.com/drylokMasonry/patching/crackFiller.php]UGL - DRYLOK® Masonry - Patching[/url] to fix the minor cracks in the masonry, and to provide additional support for mason that has become soft and thus not completely brushed out (these spots only get brushed out abit more then usual). Basically to add a bit more protection in these areas. The Hydrolic Cement that Drylock provides will set in about 5 minutes (according to UGL technical support). This is a very short period of time, and the amount of damage that is done (2 spots of over 6 feet) would take a significant amount of applications and mixing to work. I want this fix to be permanent, so I would rather spend more money and/or more time for the best solution. Lastly there is Muriatic acid verse Drylocks etching material. The Drylock ething material will cover around 300 square feet per bottle, I am not sure about how much area the Muriatic acid will cover. The application of this will be above my head, so application will require a brush with a handle on it. Cleanup is a issue, though I can get a hose to wash it off. I also have latex paint on the walls, I have cleaned this up the best I can. I have tried using stripper (I used it inappropriately) and had a extreme mess on my hand. The fumes were horrible, and the cost to remove all of the paint this way would be extreme. I have a 2200psi pressure washer, however the ammount of moisture using this in a closed basement would soak everything. If the acids would also remove some of the paint safely, I would be VERY happy! I have a floating basement with a sub pump. Water runoff from washing these chemicals away will end up in the sills between the floating slab and the wall. I am assuming these chemicals will eventually move bellow the floating slab. I expect that these chemicals will end up in the sub pump. This will no-doubt cause damage to the sub pump no doubtly leading to a short life cycle of the pump.Read More
Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete
Replacing concrete steps with wood

I

igolf2 on Oct 11, 2009

Hi, my small front porch had the preformed concrete steps - we just had a new asphalt drive installed and had the contractor remove the steps and cut out a hump or rise that was dangerous in the winter - I now have a flat asphalt surface and want to build wood and composite (Trex) covered steps ( 4 steps up) My questions are - easiest way to attach steps to the conctrete block that is the base to the top concrete pad - I was thinkin heavy duty toggles. and best way to anchor bottom section of steps to the asphalt. Any info would be appreciated. ThanksRead More

Ask a Question