DoItYourself.com Community Forums > Exterior Improvement Center > Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete

Klear & Seal 25 LV - Results are blotchy

Thread Tools

Search this Thread

10-11-09, 06:14 PM

greg52

Member

Thread Starter

Join Date: Oct 2009

Location: PEORIA ILLINOIS

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

Klear & Seal 25 LV - Results are blotchy

I applied to my new driveway Klear and Seal 25 LV using a Chapman Icon sprayer with 1 gpm nozzle. I thought I was careful to not get it on too thick but as it is drying it is very blochy , you can visibly see where I applied it too thick.
Is there anything I can do to fix it. It looks bad.

greg

Upvote

10-12-09, 08:48 AM

Pulpo

Temporarily Suspended

Join Date: Jul 2008

Location: NY

Posts: 10,265

Upvotes: 0

Received 0 Upvotes on 0 Posts

I'd remove it with a power washer & never seal it again.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete
Replacing concrete steps with wood

I

igolf2 on Oct 11, 2009

Hi, my small front porch had the preformed concrete steps - we just had a new asphalt drive installed and had the contractor remove the steps and cut out a hump or rise that was dangerous in the winter - I now have a flat asphalt surface and want to build wood and composite (Trex) covered steps ( 4 steps up) My questions are - easiest way to attach steps to the conctrete block that is the base to the top concrete pad - I was thinkin heavy duty toggles. and best way to anchor bottom section of steps to the asphalt. Any info would be appreciated. ThanksRead More
Bricks, Masonry, Cinder Block, Paving & Walking Stones, Asphalt and Concrete
How to Repair Heaved Concrete Driveway Apron

E

edge10 on Oct 12, 2009

I have a 5 yr driveway apron which has heaved. It is about 1/2 inch above the concrete sidewalk and has a 3/4 gap between the expansion joint material and the sidewalk, so water now drains in the gap. As you would expect the drainage is poor on the rest of the apron, since it has settled 1 inch below the drop curb. Is there a way to repair this or least fill and seal the gap to minimize the water entry?Read More

Ask a Question