My house has the original steel casement windows from 1926, which are embedded in stucco. So replacement has been discouraged. Perhaps because of too much accumulated paint, or ... whatever, I cannot close a couple of the windows. Does anyone have experience with metal casement windows? Is it the paint on the hinges, or is it rust that prevents them from closing? What is the best way to clean the hinges? Any suggestions will be greatly appreciated. Does anyone know whom to call for help. [I am in Essex County, NJ.] This does not seem to be work for a carpenter. A welder might be more the right specialty. Thanks. Forums Managers Note: Title Edited To Facilitate Easier Keyword Searching.

I will be installing a double hung window 35" tall by 47" wide. Its the Excalibur by Alside. I will be finishing the ext. with wood trim. If you can help me with some of the questions below that would be great. 1. Will 2.5" deck screws be fine to use or should I use something else? 2. There are 2 holes on each side to secure the window to the framing, since this window is wide should I also screw into the top and bottom of the window to prevent any future sagging? 3. What is the removable cap that runs the length of the top of the window? Thanks, John