What is this called? [url=http://imgur.com/vCo4G6W]Imgur: The most awesome images on the Internet[/url] How do I purchase a replacement?

Hello, A newbie with a first time post. I'm replacing a recessed window on a cinder block house with a stucco finish. The original window was attached to wooden bucks that were recessed about 2 inches from the outside of the cinder block exterior and covered with mortar. I scored the stucco and broke out all the mortar around the window so I could remove the existing window. I then used 2x2 furring strips attached to the bucks to make the window a little more flush with the exterior. I used flashing tape from a home improvement store and put it on according to other sites on the internet securing it to the exterior of the cinder blocks. Now the flashing is ~3/4" recessed from the face of the stucco. If I put my window trim flush with the stucco face, that will leave an air gap between the flashing and the trim. I attached a picture of the window with the flashing tape and stucco. The trim I'm using is wide enough to cover the cuts and rest on the stucco face. (Initially, I thought I would recess the trim directly on the flashing tape but since I have more windows am not excited about chipping out all the extra stucco). Is this OK or should I fill the gap with something? Should I remove the window and fur it out so it is flush with the stucco face? Did I screw this all up? Any suggestions or pointers would be appreciated. Thank you and kind regards, Sean [ATTACH]67924[/ATTACH]