Made the mistake of buying a used washer dryer combo. Got taken for my money. Anyways...heres the deal. Washer pumps water into the tank just fine. When it goes to start the spin, theres a hum and then it stops. few seconds later, it hums again, then stops. By this point i was afraid, so i shut it off. Doesn't appear to have a drive belt at all, looks like the motor is directly attached to the drum. Think the motor is bad? And if so, where the HECK can i find a replacement??? I've looked all over. Here is the model number on this 75lbs hunk o' metal. WISCL-W-2

Hello, Any help you can provide would be great. I have a Kenmore Elite Dryer (model 110.60972990) that has decided to not run if the Start Button is not held down continuously. As soon as I let go of the Start button it stops running. I've read through many threads and decided to go purchase a new computer board, which did not help. We also switched the heat and motor relays with no change. Also, and maybe more disturbing, is the fact that I can't get the dryer to go into test mode. I found the Tech Sheet that shipped with my dryer and it says 1. Open the door 2. Set Fabric Care/Temp switch to Air Fluff 3. Set Signal Switch to Loud 4. Set Timer to Timed Dry or Auto Moisture 5. Turn Wrinkle Guard switch from OFF to ON three times within 5 seconds At this point we're supposed to hear beep but I have never heard a thing. Why would my dryer NOT go into test mode? Many thanks in advance!