DoItYourself.com Community Forums > Household Cleaning, Kitchen Appliance Service and Repairs > >Electric< Large Kitchen and Home Appliances

I need Help with my Beaumark 57481 Washer

Thread Tools

Search this Thread

06-08-08, 08:31 PM

kikitrdn

Member

Thread Starter

Join Date: Jun 2008

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

I need Help with my Beaumark 57481 Washer

Help!!! I got this washer about 2 years ago, and this morning it refused to spin!!!! I tried everything and it would not spin...Help please!!!! Thx

Upvote

06-09-08, 04:19 PM

ecman51

Banned. Rule And/Or Policy Violation

Join Date: May 2007

Location: Wisconsin

Posts: 7,826

Upvotes: 0

Received 1 Upvote on 1 Post

What all did you try?

I had a lady once say that when she could not get the kitchen floor clean, and I said, " You tried EVERYthing? I bet you did not try THIS", - and she did not, and I did, and it all came spotless.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

>Electric< Large Kitchen and Home Appliances
Maytag Clothes Washer

M

maymay on Jun 09, 2008

Good Morning. My query is two fold. 1) I am in the process of trying to remove (separate) the two tubs on this Maytag clothes washer. There was a rattleing sound during the spin cycle, as if there were a marble rolling around. Before I could shut it down, it locked up as if something is wedging the tub. I have gotten as far as removing the agitator (please view Photo Bucket pic link below.), Would the next step be to remove the four bolts displayed it the image?. I was under the impression that a "spanner wrench and a seal tool" would be needed to remove the seal nut prior to removing the inner tub but I see no application to indicate that step. Can you advise the next step please. 2) Can you advise the removal of the "tub rings" that are attached with clips to the outer tub. The information that I have thus far was obtained via internet drawing using the model number of the washer but the drawing and the actual are somewhat different. I am hoping that There is something caught in a gear that I can remove and all will be well. Make : Maytag Model number: PAV2360WW Purchase Date: 7/03 [IMG]http://i144.photobucket.com/albums/r194/sparkyrhett/MAYTAG.gif[/IMG]Read More
>Electric< Large Kitchen and Home Appliances
Kenmore front loader washer not draining

D

Danc on Jun 10, 2008

I have a front load Kenmore that is not going into the spin cycle to drain the tub. I took off the pump and found a nickel in the suction to the pump. Took out the coin and fluhed out the pump in the sink. I reconnected the pump and associated piping but it still will not engage in the spin cycle. Any ideas or suggestions before I buy a new pump? Thank youRead More

Ask a Question