Range Question: QUESTION: I have a Magic Chef oven/range. The numbers are blurry but it looks like model # 351. the two big burners are not workiing well. I have to push the elements in hard to make them work. Often that does not work so I twist them, take them out and put them back in and put them in at different angles. In other words, whatever works. This has happened to this range before and I have gotten either/ and new burners or new sockets for the burners. at least once before on this stove. The stove we had before this did the same thing with the big burners and usually the front one, which we use the most. I get tired of putting in new burners and sockets. Is there a better and easier and cheaper way to do this? This is not the first time this has happened. We have replaced the burners on this stove twice and the former stove 3 times. It always seems to be the big burners. Whenever I take the burners out I put them in tight. However, sometimes the receptacles seem to be loose or not quite hold the burners in properly and if we move a pan on the burner then it seems to move the burner and then the receptacle. I can replace the receptacle and burner but is there a way to stablilize the receptacle and burner so this will not happen again? Thanks

Technician worked on it today for about 2 hrs, tested unit, said it needed freon, added freon, checked for leaks, found a small one, fixed it. Said it would take a few hours for unit to get cold. It's been 4 hrs. and not cold yet, icemaker has not produced any ice as of yet either. Any suggestions? Thanks for your input.