DoItYourself.com Community Forums > Electrical, AC & DC. Electronic Equipment and Computers > Electrical - AC & DC

Electrical Service Panel Code

Thread Tools

Search this Thread

11-18-02, 01:11 PM

jmacc

Visiting Guest

Posts: n/a

Electrical Service Panel Code

I plan on having the electrical service panel upgraded to 200 Amp. It also is part of redesigning the basement layout. I realize code does not permit a panel in a closet or bathrooom, but is it
allowed in a bedroom?

Upvote

11-18-02, 01:28 PM

sberry27

Member

Join Date: Jun 2002

Location: Brethren, Mi

Posts: 1,564

Upvotes: 0

Received 0 Upvotes on 0 Posts

I see no reason why you couldnt put it in the bedroom, especially if the meter base is right outside.

Upvote

11-18-02, 01:39 PM

gard

Member

Join Date: Dec 2001

Location: Calgary Canada

Posts: 690

Upvotes: 0

Received 0 Upvotes on 0 Posts

You may want to check with your local inspection department as they may have a local bylaw about where the panel is placed. In the majority of places it would be allowed in a bedroom as long as the clearences are available, and the meter base is close by. They do tend to frown on unneccessary distances between the panel and meter base.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Electrical - AC & DC
why do I have a "Load Center"?

E

eaanderson on Nov 13, 2002

This is a posting I had placed in the Basements forum, but I didn't get an answer there. The experts I'm looking for are probably hanging out here instead... I'm trying to figure out why I have a "QO Load Center" box (Square D cat no Q02-4L70S to be exact) next to my main breaker box and connected to it with two electrical conduit sections. I recently went to Square D website to try to learn exactly what these are for, but the technical data I found did not really answer that. Apparently, my unit is for single-phase, 2 circuits and 70 amps max. I'm still puzzled on exactly what it does. I recall that previous home owner had a hot tub on back patio, so I'm guessing it had something to do with that. However, inside the main breaker box, there is already a (dual) breaker switch marked "WHIRLPOOL". So, I wonder if both were needed? Both the whirlpool breaker in main box AND the switch on the load center are in OFF position. I would like to move this smaller box closer to the main electrical box if it's not too much work. Or, since it appears to no longer be used, perhaps I can even remove it? Otherwise it's going to be an annoyance to my basement finishing work, as the two boxes are separated by a couple feet. Thanks for your ideas, EricRead More
Electrical - AC & DC
Grounding receptacles/switches with BX

N

njhotrod on Nov 18, 2002

Moved into a house built ca. 1960 with BX conduit. Service was upgraded to 200A about 2 years ago. Most of the 2-prong outlets were replaced with 3-prong grounded outlets, although grounds are absent. Can I run short ground wires from the outlets and switches to the box housing the receptacle or sewitch since the house has BX conduit, or is this an unacceptable ground? How would I verify? Thanks, JoeRead More

Ask a Question