Hi Folks, I'm doing some research for a basement bath installation and have some electric questions. There will be an overhead light fixture in the middle of the room, a light fixture over the sink, a light fixture inside the shower stall, a vent fan, a GFCI recepticle to serve the vanity, 3 switches to serve the lights/fan, and 120 v, ~1,000 watt electric wall-mount heater. The floor will be tile on concrete. 1) The fixture inside the shower stall - can a combo light and vent fan fixture be used, or should the vent fan be located outside the shower stall? 2) Should the 3 light fixtures and vent fan be on a circuit having GFCI protection? 3) Should the electric heat be on a circuit having GFCI protection? I was thinking 3 circuits. One for the vanity GFCI, another for the electric heat, and a third for the 3 lights and the fan. Thoughts? Thankx all for your comments !!

I have a Square D circuit box on my power pole. Have a 60amp circuit breaker installed. Have it wired for 220 but multitester indicates I have no power through breaker. Have installed new breaker, same results. All wires are either AL or CU 6/3. If I test from ground to each side of breaker, each side indicates 110 volts., but multitester still indicates nothing going to where I want power to go to. What silly thing am I overlooking? Thank you in advance for any help.