Sent by PM from TravisM: My question is I ran new wiring to install a ceiling fan with no previous fixtures. The wire I added goes to an existing wall switch. The wire I added has black, white, red, and a non insulated wire. My fan has white, black, and blue. Can you tell me what wires connect to what at the fan, and what wires connect to the light switch and how.

Have tried 4 GFCI's but keep getting "hot and ground reversed" reading from both of my testers. A lamp plugged into the GFCI will not work. Newest GFCI with little test light built in, doesn't light up Checks out OK using regular receptacle. This is a "new" system I'm putting in the kitchen. GFCI is first in the system. I have black going to the fuse. White going to the strip where all the other whites are, and ground going to the strip right along side of the white strip. Some of the grounds are going into the white wire strip block and some are going into the strip right beside it. I have a 2 GFCI systems in the bathroom and they check out OK Should the ground and white be put in the same strip in fuse box? This doesn't seem to affect other circuits.