220 wire
#1
Member
Thread Starter
Join Date: Apr 2006
Posts: 1
Upvotes: 0
Received 0 Upvotes
on
0 Posts
220 wire
I am trying to run 220 to my attached garage. I have a 240 volt air compressor and a Miller arc welder. What size wire will I need and what size breaker? If my existing panel is full, not sure yet, what do I need to do to start a new panel ? Thanks
#2
Member
Join Date: Sep 2003
Location: Central New York State
Posts: 13,245
Upvotes: 0
Received 0 Upvotes
on
0 Posts
You need more information.
Do you want to be able to run both of these at the same time? What are the current requirements of each? Is this a detached garage or an attached garage? If detached, is there electrical out there already?
Do you want to be able to run both of these at the same time? What are the current requirements of each? Is this a detached garage or an attached garage? If detached, is there electrical out there already?
#3
Member
Which Miller welder? What is the nameplate rating of the compressor motor?
What brand/type panel do you have?
What brand/type panel do you have?