installing troffer fixtures
#1
Member
Thread Starter
Join Date: Jan 2003
Location: usa
Posts: 93
Upvotes: 0
Received 0 Upvotes
on
0 Posts
installing troffer fixtures
this may be completely obvious to somebody, but not to me. I want to replace a troffer fixture, and can't figure out the best way to remove and reinstall. There is a piece of 2x4 about 2 inches above the fixture so i can't see an easy way to twist the fixture to come through on the diagonal. Is there a trick? should I remove a grid support bar and then reinstall it later? Thanks.
#2
Usually the ceiling suspension grid would not be so close to the framing. I would guess the ceiling system was assembled as you go. The best way would probably be to disassemble some of the ceiling grid to get the troffer out.
#3
There is a piece of 2x4 about 2 inches above the fixture so i can't see an easy way to twist the fixture to come through on the diagonal. Is there a trick?