Hi, I'm having an issue with a vanity light in my guest house. I noticed that it started to flicker after being on for any length of time. I took it apart to check the wire connections and discovered that the black from the feed is connected to the black on the fixture but the white wire from the feed is simply capped off with a wire nut and not connected to anything. The white wire from the fixture is connected to the ground wire from the feed. This light comes on with another light located in the bathroom with the same switch. I tries connecting white to white on the vanity but the strange thing is the bathroom light comes on when I put a bulb in the vanity light without turning the switch on. Also the white wire coming from the wall for the vanity is always hot. I attempted to make a diagram of this mess because I know I've definitly confused myself already!!:confused: Thanks, Levi

i recently installed 8 plastic overhead boxes with Porcelian Lampholders using the new bulbs that use 14watts apiece. I used 12-3 wire on a 20amp breaker. Every time I try to turn on the breaker it pops. I have the lights on two switches where you can turn on the lights on one side of the room and off on the other side of the room. Can't figure out what I did wrong, any suggestions?