DoItYourself.com Community Forums > Electrical, AC & DC. Electronic Equipment and Computers > Electrical - AC & DC

Wire Size

Thread Tools

Search this Thread

06-21-14, 06:53 AM

Patiswired

Member

Thread Starter

Join Date: Jun 2014

Location: United States

Posts: 1

Upvotes: 0

Received 0 Upvotes on 0 Posts

Wire Size

What is recommended wire gauge for 40 amp service? Should be 30
Amp! Not 40

Upvote

06-21-14, 09:33 AM

ray2047

Member

Join Date: Mar 2006

Location: USA

Posts: 29,711

Upvotes: 0

Received 15 Upvotes on 13 Posts

Your post doesn't make sense. Please explain more fully.

Upvote

06-21-14, 11:51 AM

pcboss

Forum Topic Moderator

Join Date: Jul 2002

Location: Maryland

Posts: 13,935

Upvotes: 6

Received 181 Upvotes on 159 Posts

The smallest service you can install for a house is 100 amps.

You you asking what size wire is needed for a 30 amp circuit? If so more details are needed.

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Electrical - AC & DC
Adding outlets in garage

J

JamieO on Jun 21, 2014

I recently purchased a home (existing construction) that only has a couple of outlets in the garage and as luck would have it, none on the side of my work bench. So, I'd like to add some outlets. The attached image is a rough sketch I've done of the garage. The main garage area is drywalled but the small storage closet at the back is not, so I have access to the studs there. The EO 1-3 shows where the 3 existing outlets are. I numbered them in order of where they seem to fall in sequence (seems as if the existing line goes to 1 first, then 2, then 3). The 3 "NO" show where I'd like to locate new outlets. I am thinking that doing surface conduit and boxes are the way to go, but have a couple of questions: - I can easily access existing outlets 1 & 2. Both of them have power coming in and going out. Can I run an additional line out of one of these, or is 1 line out the max in a single run? I'd like to avoid adding a new line (and therefore dealing with the box) if at all possible. - What are the pros/cons of the metal vs PVC surface-mount conduit? I am a typical homeowner and don't have any kind of advanced wood working shop with lots of tools. My power needs are limited to stuff like running a circular saw, charging kids' toys and batteries in the cordless drill. So, I don't anticipate needing anything major power-wise. Thanks for any suggestions on how to best knock this out.Read More
Electrical - AC & DC
Setting up Push-To-Break Switch

N

Nick Jones on Jun 19, 2014

Hello, first time poster here. I've tried searching for a relevant thread, but couldn't find anything that helped. So, here is my problem. I want to set up individual push to break switches for my dresser, which upon opening each, will light up. I am hoping to use led strips, and put the switches in the back of the drawers. I assume I will be using refrigerator switches, so my power flow would look something like: outlet-power adapter-4pin adapter-leds-reverse 4pin adapter-switch. Just looking for some guidance/corrections/information on the idea and how or if you would do things differently? Thanks!Read More

Ask a Question