Raised metal duplex cover for 4-11/16 box
#1
Member
Thread Starter
Join Date: Nov 2011
Location: usa
Posts: 188
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Raised metal duplex cover for 4-11/16 box
I have used the half inch raised metal duplex covers in the past for standard 4" boxes which were attached directly to the wall in a basement or garage.
Do the same covers exist for 4 11/16 boxes?
I can't seem to find them readily available
I know the work around would be the 4" adapter plate but then I would have to use the plastic cover
Which will look odd on the surface mounted box.
Note- i was able tho find one doing a search sold by platt
But they were ridiculous expensive.
Any thoughts
Thanks
Do the same covers exist for 4 11/16 boxes?
I can't seem to find them readily available
I know the work around would be the 4" adapter plate but then I would have to use the plastic cover
Which will look odd on the surface mounted box.
Note- i was able tho find one doing a search sold by platt
But they were ridiculous expensive.
Any thoughts
Thanks
#2
Try this one. It is a box of 10, so about $8 each.
Raco 4-11/16 in. Square Single Gang Exposed Work Cover for Duplex Device (10 Pack)-972 - The Home Depot
Raco 4-11/16 in. Square Single Gang Exposed Work Cover for Duplex Device (10 Pack)-972 - The Home Depot
#3
But they were ridiculous expensive.
#4
Check this out 20 4 11 16" x 2 1 8" Deep Metal Box w Built in 2 Gang Adjustable Raised Ring | eBay
Can you use 2 gang rings?
Geo
Can you use 2 gang rings?
Geo
#5
They can be hard to find, especially in odd configurations. I have had good luck ordering single pieces through Ace Hardware when the supply house wanted me to buy a whole case. Go through the Raco catalog to find the part number you need (Raco Catalog), then take that to the hardware or supply house to order it.