This a bathroom wall heater which we never used since the bath has no exterior walls and has been always comfy without any extra heat but the other day I tried to use it and it does not work. Have been in this place for 10 years and the building is another 10 years old so the heater is 20 years old assuming it was never replaced before I open it up and the insides looks like brand new . Its controlled by a wall thermostat and I do have power at the heater but it does not work no matter how much I turn the wall thermostat. A new similar unit cost about $160.00 here Any idea what I need to check to find out what’s wrong with it? [attach]102888[/attach] [attach]102889[/attach]

This is the room i need wired but i dont know how to do this properly . The light 1 corresponds with switch 1 and so on .. i would prefer this all on 1 circuit if possible i have a feed wire from box at 10 awg on a 30 amp breaker all new .. breaker should maybe be reduced idk if 30 amp is to much but i know its rated wire for 30 amp [attach]102929[/attach]