Terminal block from generator switched neutral kit

Reply

  #1  
Old 12-16-17, 09:27 PM
Member
Thread Starter
Join Date: Oct 2017
Location: US
Posts: 20
Received 0 Votes on 0 Posts
Terminal block from generator switched neutral kit

I am going to install a Generac switched neutral kit for my Generac transfer switch. It seems pretty straightforward but I canít figure out what to do with the insulated terminal block they give you to run the neutrals through. There doesnít seem to be a way to affix it to the inside of the breaker panel as shown in the instructions. Am I meant to just let it hang by the neutral wires? That seems awfully sloppy.

Thanks for ideas. I am sure some of you have installed these before.
 
Sponsored Links
  #2  
Old 12-17-17, 05:15 AM
Geochurchi's Avatar
Member
Join Date: Nov 2012
Location: USA
Posts: 4,029
Received 18 Votes on 18 Posts
Hi, not much to go on here,can you post the instructions or the model # of the switch?
Geo
 
  #3  
Old 12-17-17, 06:51 AM
Member
Thread Starter
Join Date: Oct 2017
Location: US
Posts: 20
Received 0 Votes on 0 Posts
  #4  
Old 12-17-17, 07:43 AM
Member
Join Date: Feb 2016
Location: United States, Virginia
Posts: 1,176
Received 23 Votes on 19 Posts
Use double faced foam permanent mounting tape.
 
  #5  
Old 12-17-17, 10:15 AM
Member
Thread Starter
Join Date: Oct 2017
Location: US
Posts: 20
Received 0 Votes on 0 Posts
Ah, good idea thanks. There's a ridge on the back of the block that will get in the way, but I can put a few layers of tape on.
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes
 
Ask a Question
Question Title:
Description:
Your question will be posted in: