100amp sub panel and bonding screw?
#1
05-30-01, 06:13 PM
Visiting Guest
Posts: n/a
I'm preparing to install a 100amp subpanel in my garage. I've already purchased the panel and I'm curious as to what to do with the bonding screw included. The panel did not come with a ground bus bar so do I need to pick one up? Thanks, Marcus
Sponsored Links
#2
05-30-01, 06:22 PM
Visiting Guest
Posts: n/a
Marcus,
Is the garage attached to the house?
How many wires are you running from the power source to the garage panel?
Don
Is the garage attached to the house?
How many wires are you running from the power source to the garage panel?
Don
#3
05-30-01, 06:43 PM
Visiting Guest
Posts: n/a
The garage is sort of attached by a "breeze way". I was planning on using #4 copper(3 conductor & ground)? I'm not sure if I'm going to bury it or snake it through the breeze way. It's approximately 25ft.
#4
05-30-01, 06:50 PM
Member
Join Date: Sep 2000
Location: United States
Posts: 18,497
Throw the bonding screw in the trash. Buy a grounding bus bar.
«
Previous Thread
|
Next Thread
»
Linear Mode
