motor resets
#1
Member
Thread Starter
Join Date: Oct 2019
Posts: 2
Upvotes: 0
Received 0 Upvotes
on
0 Posts
motor resets
the motor on my unisaw stops under slight load. wait a few minutes and it will re start. runs for a bit but trips off again.
#5
It's also possible the overload protector could be bad. It's a rare problem, but does sometimes happen. Klixon is the brand I remember.
https://www.ebay.com/b/Klixon-Indust...45/bn_17642693
Forgot to mention that a dull blade increases the load tremendously. Be sure you have a good sharp blade on the saw.
https://www.ebay.com/b/Klixon-Indust...45/bn_17642693
Forgot to mention that a dull blade increases the load tremendously. Be sure you have a good sharp blade on the saw.
Last edited by CasualJoe; 10-23-19 at 10:18 AM.
#6
Member
https://www.sears.com/craftsman-cm/p...hoCaOcQAvD_BwE
$28 gets you a badly needed ammeter. This will lead you to a solution without guessing.
$28 gets you a badly needed ammeter. This will lead you to a solution without guessing.