Delta 507X table saw
#1
Member
Thread Starter
Join Date: Feb 2004
Location: Milwaukee
Posts: 131
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Delta 507X table saw
I'm having trouble aligning the pointer for the angled blade adjustment. When I Zero the blade the pointer is off by 5 degrees. I've tried everything but bending it into submission.
Is this common with Delta saw adjustments? Any solutions?
Is this common with Delta saw adjustments? Any solutions?
#2
dogman1953:
I own an older Delta and the pointer on mine has to be bent to set it.
Keep in mind that the pointer is just a guide and is not accurate enough for the final setting.
I own an older Delta and the pointer on mine has to be bent to set it.
Keep in mind that the pointer is just a guide and is not accurate enough for the final setting.
#3
Member
Thread Starter
Join Date: Feb 2004
Location: Milwaukee
Posts: 131
Upvotes: 0
Received 0 Upvotes
on
0 Posts
I knew that but, I thought it would have been close evought to not have to bend it into place. It is obvious that the pointer is useless.
I check my alignments with each project anyway.
I check my alignments with each project anyway.