miter slider needed for harbour freight 10 in table saw

Old 03-07-10, 05:09 PM
Thread Starter
Join Date: Mar 2010
Location: az
Posts: 1
Upvotes: 0
Received 0 Upvotes on 0 Posts
miter slider needed for harbour freight 10 in table saw

I need the miter slider for harbour freight 10 in table saw. It looks like the T_slot in the table is smaller than the miter sliders I see in Internet from Incra. It appears to be 5/8 in wide with 3/4 opening at bottom and 1/4 in high.
I'd like to know how to get a slide for this table saw for a jig I'd like to make. Any ideas would be appreciated.
Old 03-07-10, 05:31 PM
XSleeper's Avatar
Group Moderator
Join Date: Dec 2004
Posts: 26,668
Received 1,812 Upvotes on 1,629 Posts
You might check ebay for something like this one, I know some of the Ryobi miter gauges are not 3/4" wide. You will probably have to ask the sellers for the exact measurements (and be sure of yours)
Old 03-08-10, 04:45 AM
Forum Topic Moderator
Join Date: Mar 2005
Location: USA - N.E.Tn
Posts: 45,414
Received 786 Upvotes on 689 Posts
If HF still sells the same saw you should be able to buy replacement parts thru their service dept.

Thread Tools
Search this Thread
Ask a Question
Question Title: