Need advise on the use and practicality of an electric (corded or cordless) nail gun. The main use of this gun will be to re-nail the inside ridge board on my cabin. It's a vaulted ceiling and is about 18 feet high from the floor. I'll be using a generator for power. Although I'll find many more uses for this tool I don't want to spend too much since the only real reason is for the above mentioned job. I have a pneumatic nailer but getting the compressor up the mountain side will be a challenge and I'm not sure my generator could handle the air compressor demands. With that said I looked at Harbor Freight and they only seem to have a stapler/nailer in an electric configuration. BTW the ridge board I'm nailing is a 1 x 3 strip. I'd have a hard time using a normal hammer in that position. So my question is, any suggestion as to what to buy or brands to look at? And thoughts if the nailer will even do the job. EDIT...Any thoughts about this one? DeWalt DWHT75021 Electric Multi-Tacker [url]https://www.google.com/shopping/product/2146238748695374502?q=electric+nail+gun&client=firefox-b-1-d&biw=1280&bih=571&dpr=1.5&prds=epd:14610754275772052175,paur:ClkAsKraX-WQgeIFSkHdBjIF6L6dRb28X2EVdWiY0tCuJDKXrIdJ_3EpX5zMOy9pBQfKA6Qf0aZVdkNyXInKjDFr62ibHx1WI4hVtIA4JRwbPGwJNWxJGZkI6BIZAFPVH7014okrNPcvIHJTLB8lbHmI6vr8AA,prmr:1&sa=X&ved=0ahUKEwieg8qfvunjAhWw1FkKHbwPC5AQ8wII-gM[/url]

I purchased a Craftsman air compressor in 2005: Model: 919.167320 2 hp 33 gallons Vertical Permanently lubricated Single stage. It has been in storage since about 2007. There have been various storage conditions since then. It has been stored in NC, WI, NY, and now Michigan. None of these units were climate controlled. I'm trying to put it back in service and I 'd like some advice on what I should look out for when getting it back to safe operating order. This will be used to run paint guns a few times per week. Thanks in advance!