Wiring glass break sensor
#1
Member
Thread Starter
Join Date: Dec 2008
Posts: 9
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Wiring glass break sensor
We did some repairs and had to unhook our flexswitch sensor wires at the window site. Now we can't remember how to rehook them. There is a red wire, black wire, green wire and white wire. The sensor has slots for (Top to bottom)
C, NC, V-, V+, TMPR, TMPR
Can you advise as to which slot each color wire goes into.
C, NC, V-, V+, TMPR, TMPR
Can you advise as to which slot each color wire goes into.
#2
Forum Topic Moderator
Unless they did something wierd, red goes to V+ Black goes to V-, and the remaining pair go to C and NC (it doesn't matter which goes where, it's just a normally closed switch). The tamper terminals aren't used.
#3
Member
Join Date: Mar 2009
Posts: 4
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Is this the same as Aurora Pir because my slot said:
[+] [-] [R] [R]
i wire + with terminal 11 in 128fb (i gues its +12Vdc)
- with terminal 12 (i guess its 0Vdc)
"R" and "R" dont know what to do
[+] [-] [R] [R]
i wire + with terminal 11 in 128fb (i gues its +12Vdc)
- with terminal 12 (i guess its 0Vdc)
"R" and "R" dont know what to do