DSC 1555 programming

Reply

  #1  
Old 09-24-13, 03:50 PM
H
Member
Thread Starter
Join Date: Sep 2013
Location: USA
Posts: 1
Received 0 Votes on 0 Posts
DSC 1555 programming

We found your first step instructions for programming our DCS 1555 keypad and got to the point that all zones were assigned a type. Thank you for making sense of the lingo in the instruction book. We have 5 zones: downstairs door, downstairs motion, upstairs door, upstairs motion and garage motion. They were assigned types: 2, 3, 2, 3, 1 (I think -doing this from memory from a week ago). However, on completing the steps outlined, all zones show a red light. We reset to factor settings and went through the steps again with same results. We checked wiring and made sure PGM 1 and PGM 2 were separate as I read on another post. Any ideas?
 
Sponsored Links
  #2  
Old 09-24-13, 06:28 PM
M
Forum Topic Moderator
Join Date: Jun 2000
Location: Gainesville, FL, USA
Posts: 16,640
Received 88 Votes on 83 Posts
Did you either install the 5.6k resistor in series with one leg of each loop, OR turn off the requirement for the resistors?
 
Reply
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: