I am installing from 5820Ls in our bedroom. The wife and I like to leave the windows open at night for coolness and fresh air. I would like to set the 5820s on the windows to be disabled when in STAY mode but active in AWAY mode. Is this accomplished by setting the loop number from 1 to something else (i.e. what?), setting the zone type to something other than perimeter (i.e. what?), or another way? Thanks in advance.

My GE Concord 4 Series home security system has run flawlessly for the last 8 years. Last week, I received the "CPU Battery Low" system fault with the associated beeps. I have since replaced the 12V 4.5ah battery (30 hours ago). [Unplug old battery, unplug system, plug new battery in, plug system in to AC power]. The panel constantly displays "Press Status"; and when you press "*" either once or twice, the "trouble SIREN" displays. The ready light will not come on either. I have the full manual, and there is no mention of this fault. Testing the siren/panic mode for Fire, Police, Medical all sound the siren. After testing the 3 panic buttons, the "ready" light stays on for a few seconds, and then goes off (so I know the light works). Pressing the * + * initially gave a "set time" and "SIREN" fault. After setting the time, the only fault is "SIREN". All sensors are tested via sensor test method and are working fine, however, the green "Ready" light will now not go on. I have the master code, and for the life of me, cannot get to any menu that clears the faults, or allows me to "ready" the system and clear the "SIREN" trouble. I'm at a loss.