AM3 Bus Unit Failure

Reply

  #1  
Old 11-25-15, 10:19 AM
Member
Thread Starter
Join Date: Nov 2015
Location: USA
Posts: 1
Received 0 Votes on 0 Posts
AM3 Bus Unit Failure

Good afternoon.

I have a GE Concord 4 alarm system. I've had it connected to a Control 4 system, but have disconnected the Control 4. What else do I need to do to get this operating independently again and get rid of the AM3 error?

Thanks.
 
Sponsored Links
  #2  
Old 11-25-15, 01:32 PM
Forum Topic Moderator
Join Date: Jun 2000
Location: Gainesville, FL, USA
Posts: 16,173
Received 28 Votes on 27 Posts
Sounds like you disconnected the automation interface module.

You would need to delete that device from the system.

If you have access to programming (have the installer code)

see page 71 in the manual: http://site.geoarm.com/pdfs/GE/conco...tall-guide.pdf
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes
 
Ask a Question
Question Title:
Description:
Your question will be posted in: