Hello...
I am a network tech but never installed a security system... I inherited a Interlogix Concord 4 Hybrid Starter kit #80843 and I am planning to install it in my home.
I need a list of compatible devices to purchase
This unit doesn't come with a transformer
I need:
3 basic wired interior motion sensors
10 wireless door/window sensors
Outside siren
Key FOB
3 Wireless smoke sensor
1 Wireless heat sensor
No cellular needs, just want the unit to call me and set off the siren
I am not sure if anything else is required to make this panel wireless
Any advice is appreciated,
Bob

 

Installer manual: http://site.geoarm.com/pdfs/GE/conco...tall-guide.pdf

Manufacturer's site: Concord 4 | Residential Security | Commercial Security | Interlogix Global Security Products

Between the two, the specifications of all of the compatible components with their proper names and part numbers are available.

 

I purchased a wireless receiver #60-764-01-95R-16Z for a Concord 4 Hybrid panel I have…I downloaded the manual and I see the figure for wiring the GND, +12V and BusA & Bus BMy panel only has (1) +12V and BUS A & BUS B connector, and I already have the ATP1000 keypad connected to those connectors…Do I also just connect the Wireless Receiver to the same connectors that the ATP1000 is using?

 

Yes.... you can connect both devices to the same four terminals.

This is what happens when you have too many AUX devices.

 

You don't need to buy an external receiver...There's already one built into the motherboard