So I had to redo my entire system from the ground up (except hard wiring) I replace my Vista 20 with a 21ip. I also replaced all my keypads, 6139 for 6160s. l replaced the siren. I replaced all window contacts. I didn't do anything fancy at the panel. No zone doubling. no smokes. I do have an Envisalink IP board installed. I also have 2k resistors for each zone at the panel on the HI side. (for those that want to argue that there's no point when they're installed at the panel, I get it.) Here's the problem, All my Entry/Exits work just fine. The motions work just fine. However, the perimeters are not working at any window. I've tried NO, NC, EOL and they just don't register when I open or close a window. If I change to either NO or NC with the resistor wired in the keypad does show a fault but no action when opening or closing. All windows are wired in series. I've tried removing the contact and shorting back to the panel and I get a ding during walk test so my thinking that the wiring is OK. My Fluke gives me a nice healthy ring at the probe for each zone wire so I think I've got all my zones correctly identified. Since it's all windows I feel like I missing one configuration step but I can't find anything in the manual or online. Can anyone help me?

Need some help with an older DSC Alarm System. I have a SCW9047-433. 1. Trying to add some additional sensors. Trying to add a keyfob WT4989 and a Siren WT4901 They would not install on the quick install, so I accessed by entering 804 to add manually. My keypad only allows a 6 digit serial numbers and these have 8. What do I do? Also how do I ensure it's labeling the zone type correctly? 2. I also manually added another smoke detector and carbon monoxide detector, how do I test them and check the zone definitions?I have a SCW9047-433 or also known as DSC system. My keypad only allows a 6 digit serial number and these have 8.