This is my first post here. I'm nearly 70 but do have a general understanding of electronics and computers - built system in past, but as time goes on technology expands leaving me behind. I bought a Vista 20P panel with (2) 6160V keypads. I also installed an wired expansion 4229 and programmed it to Address 08 (for zones 17-24). This part of the system has been working fine. Even entered Alpha Codes and created Custom Words. I have only had this system for 4 day's and learning. I then installed a 5881enh wireless RF Receiver, but ((cannot)) make it talk to the 20P panel. The receiver sees my added wireless sensors her on my bench - as noted by the red light flashing led when I trip the sensors. The green light is out and has never lite up (meaning available zones). I tried at first to program the 5881enh to address 07 (for zones 09 to 16) for my wireless devices. Did not work. I changed the 5881ENH back to default with all dip switch "off" or assume address 00... did not work. Using my 6160V keypad and *56, Starting with Zone 09, I have tried programming zones 9 to 16 but it only allows for default RF transmitter, not an RF Receiver. I am missing something here. I believe the data is not being transmitted to the 20P from my 5881enh via the data cable or the 20P does not know it is there. I have also checked the wires, and even replaced the data cable once - just to be sure, but still does not work. I did also recycle the system to make sure the 20P updated itself and/or detected the 5881enh - assumed it did. Questions: 1) dip switch setting recommended on 5881enh. 2). What ( * ) code to use to program the 20P to look for the 5881enh 3). Since no RF Transmitter when programming *56, Zone 09, how to get pass this. 4). Instead of RF, do I treat zone 09 as a Perimeter using 03? I'm a beginner on this 20P and tried to cover all the bases.... I'm lost with this 5881enh. Help! Thanks, Norm

I have a DSC 1832 NK with a DSC RF5132 - 433 and my keypad is a PTK5507 with an Invisalink 4. My problem is that all zones are showing up on my screen. I've named them all. I've put all my sensors in place but only the 1 through 16 are working properly 17 through 24 are not. They are all the same type of wireless sensors. I just don't know if I forgot to do something in the programming. I also only see 1-16 on my eyzeon app. can anyone help. Thanks