How to cut this moulding?
#1
Member
Thread Starter
How to cut this moulding?
The bottom piece of moulding has to be replaced. How can I measure and cut this angle with a hand saw?
Thanks!
Thanks!

#5
Angle
Measure the angle with a t-bevel:
Johnson T-Bevel-B75 - The Home Depot
I would measure the angle from the remaining piece which is not being replaced since the piece being replaced is not fitting very well.
Johnson T-Bevel-B75 - The Home Depot
I would measure the angle from the remaining piece which is not being replaced since the piece being replaced is not fitting very well.
#7
But the point Joe was making is it will be quite difficult to get a nice tight fitting joint using a handsaw and cutting the angle off of a line or old piece as a guide BUT a little bit of well placed caulk can hide a lot

#9
There is no reason why you can't get a good joint using a hand saw. Finish carpenters and cabinet makers got perfect joints for hundreds of years before miter saws came along.
I don't know what tools you have or what you want to spend but that joint can be made perfect by using a good quality backsaw or Japanese pull saw. You can buy a tool (Sterrett makes a good one) to measure the angle (15*?) or you can make your own with two pieces of wood and a screw. If you make your own tool to get the angle you can use it as a guide fence to make the cut.
I agree that the existing joint is a "bit loose". Depending on how tight you want the joint you could also get it close and fill it with caulk and paint it.
I don't know what tools you have or what you want to spend but that joint can be made perfect by using a good quality backsaw or Japanese pull saw. You can buy a tool (Sterrett makes a good one) to measure the angle (15*?) or you can make your own with two pieces of wood and a screw. If you make your own tool to get the angle you can use it as a guide fence to make the cut.
I agree that the existing joint is a "bit loose". Depending on how tight you want the joint you could also get it close and fill it with caulk and paint it.

#10
There is no reason why you can't get a good joint using a hand saw. Finish carpenters and cabinet makers got perfect joints for hundreds of years before miter joints came along.

#13
It depends on the box, some have 3 slots but some have 5 - which is what you'd need. Some miter boxes are built better than others, the cheap built ones can get wallowed out in no time. IMO you can't beat a power miter saw!