airstone on corners with miter saw


  #1  
Old 06-30-17, 07:44 AM
R
Member
Thread Starter
Join Date: Jun 2017
Location: USA
Posts: 2
Received 0 Votes on 0 Posts
airstone on corners with miter saw

hello all. i am putting up airstone on my fireplace. i figured out the angle i need for the 2 edges, 49.5 degrees with my miter saw. the question i have is, should i cut the same piece and put those ends together on the edges, or cut 2 different pieces and connect them. i think the same piece would look better and like that piece is continuous over the edge, whereas 2 different pieces, albeit easier, would cause the seem down the edges to look more obvious. does that make sense? thanks in advance for your advice or tips!

Name:  20170624_114552.jpg
Views: 1541
Size:  20.6 KBName:  20170624_114415.jpg
Views: 1762
Size:  20.6 KB

example i found on google:
Name:  57f2f97492e6c53d2ade2f3668a6879b--airstone-wall-airstone-fireplace.jpg
Views: 5601
Size:  13.3 KB
 
  #2  
Old 06-30-17, 08:20 AM
Marq1's Avatar
Member
Join Date: Sep 2016
Location: USA MI
Posts: 7,529
Received 537 Votes on 497 Posts
i think the same piece would look better
Absolutely.

I've heard of this but never seen, so it cuts with a miter saw??
 
  #3  
Old 06-30-17, 09:27 AM
R
Member
Thread Starter
Join Date: Jun 2017
Location: USA
Posts: 2
Received 0 Votes on 0 Posts
they say all you need is a hacksaw, but thats super slow. so most sites recommend a miter saw, tile saw (if you dont mind getting it wet), or even a dremel.
 
 

Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description:
Your question will be posted in: