wooden fence rail location

Reply

  #1  
Old 01-08-19, 03:03 PM
Member
Thread Starter
Join Date: Jan 2019
Location: United States
Posts: 2
wooden fence rail location

I'm building a wooden privacy fence on metal posts using oz fence connectors. I'm currently attaching my bottom rail and not sure I'm doing it correctly. My first 8 foot 2x4 is about a foot off the ground. As I continue, I notice the rail is getting closer to the ground. I'm using a level. Is this the correct way to do it, or should I put the bottom rail the same distance off the ground? Thanks
 
Sponsored Links
  #2  
Old 01-08-19, 03:11 PM
Forum Topic Moderator
Join Date: Mar 2005
Location: USA
Posts: 44,533
Welcome to the forums!

I'd keep the 2x4s straight as it's easier that way. You might need to stairstep the 2x4s a little on each section depending on how the land lays.
 
  #3  
Old 01-09-19, 06:31 AM
Member
Join Date: Feb 2006
Location: USA
Posts: 6,474
I usually agree with Mark, but not this time. When stick building a privacy fence, I think you should follow the lay of the land. Locate the bottom rail the same distance from the ground at each post. Then upper rails equidistant from the bottom rail. Just my 2 cents. Good luck with your project.
 
  #4  
Old 01-09-19, 06:43 AM
Forum Topic Moderator
Join Date: Mar 2005
Location: USA
Posts: 44,533
While seeing the lay of the land might alter my advice, IMO it's easier to make 90° cuts than try to figure the angle needed to follow the land. It shouldn't hurt for the fence boards to go down further so they follow the grade.
 
  #5  
Old 01-09-19, 04:54 PM
Member
Thread Starter
Join Date: Jan 2019
Location: United States
Posts: 2
Thanks for all the replies. The grade isn't bad. I went out today and actually measured, ground to bottom of rail, and it starts out at 8 1/2 inches and goes down to 4 inches. This is my first fence and just want to do it right. I think using the oz connectors would make it hard to follow the grade?? I'm not sure how I would do that since the ends of two rails attach to one connector. Do you think the 4 inch difference will look bad once the entire fence is finished? thanks again
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
Display Modes