Hi all, I am a new home owner and recently found out that I had termites in my garage. My exterminator recommending removing the based wood around the floor of the garage to prevent further infestation.I believe that this was left over from when the house was being built as a frame. The wood was covered with concrete and painted. However, it is about 3 inches think and extremely hard to remove. This is partially because it is joined to the floor with concrete. I have tried using a crow bar and hammer to remove the wood in front of the garage to house door. However, this did not work and I had to break off small pieces of wood at at time with the crowbar. To make matters worst, the next portion of the wood to be removed is under the garage wall (dry wall). Is there a specialized tool for doing this job? How can I get this done quicker and properly? I've place pictures of the problem area on the follwing website. I'de really appreciate any advice that you can offer. [URL=http://basewoodproblem.8m.com/]Pictures of Problem Area[/URL] [url]http://basewoodproblem.8m.com/[/url] Thanks!

I'm ready to install my garage door. At the moment the opening is 2" bigger then the actual door. What size should the opening be in relation to the size of the door? I need to put a frame of a least 4" around the opening. Is a 2 x 6 to thick for that purpose? Tx for any input.