DoItYourself.com Community Forums > Exterior Improvement Center > Garages, Garage Door Openers, Work Shops & Sheds, Breezeways and Carports

Workshop Area for Garage

Thread Tools

Search this Thread

10-15-00, 08:53 AM

Guest

Visiting Guest

Posts: n/a

I am interested in locating plans for a workshop area in my already existing garage. I have been unable to find any plans. I am a true beginner to building and need detailed plans. Any suggestions?

Upvote

10-15-00, 03:37 PM

Guest

Visiting Guest

Posts: n/a

This weekend and next, Norm Abram "New Yankee Workshop" is building a workshop in a garage. You can buy plans through them.

The first episode was pretty good.

More than a Carpenter: Home repair & construction

http://www.carpenter.cjb.net

Upvote

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Garages, Garage Door Openers, Work Shops & Sheds, Breezeways and Carports
Garage joist support

on Oct 10, 2000

I have a tall garage, and want to put a storage space above the garage doors, for about half the garage's depth. The garage is 20' feet wide; so I need a 20' beam across, then joists to support the deck. There's a serious steel beam above where my new beam should go. Question: does it make sense to drill and tap the steel beam and run a threaded rod down to support the middle of the 20' span? Will one 3/8" rod in the middle suffice? More? Thicker? Or is there a better way I've completely missed? Putting a post down to the floor dead center in the garage would interfere with car doors... Also, for fire protection should I wrap the rod(s) somehow? The beam is wallboarded because of living space above. I can figure the joist loadings, but I'm not sure how to calculate for the beam spanning across the joist ends.... Thanks for any advice!Read More
Garages, Garage Door Openers, Work Shops & Sheds, Breezeways and Carports
Trusses and gables on a garage

on Oct 14, 2000

I've put up my walls and trusses and plywood on the roof.Before I move forward I'm told to run a string (with 2 nails) from the top of the gable to the bottom of the truss to align it. I don't have the foggiest idea what that's all about. Couldn't I just use an 8 foot level and make sure each stud on the gable is level? Help!Read More

Ask a Question