Garage door motor runs, but chain does not move

Reply

  #1  
Old 02-04-18, 01:00 PM
Member
Thread Starter
Join Date: Feb 2018
Location: United States
Posts: 1
Received 0 Votes on 0 Posts
Garage door motor runs, but chain does not move

Greetings,

I have a Lift Master model 139.53675SRT2 garage door opener that previously I had an issue with it getting stuck on the stop bolt when opening, so I loosened the chain to release the tension, ran it down and then re-tightened, and then lowered the up travel and it seemed to work fine for about 2 months.

Just the other night, we tried to open the door and it got stuck about half way up. The door moves fine on the rails with the manual release engaged. However, when we press the opener, it sounds as though the motor runs, but the chain does not move at all. If I hit the button again, it sounds like the motor reverses and tries to run in the other direction, again with no chain movement. It then stops when I hit the button a 3rd time.

I removed the cover plate partially and this is what the gears looked like inside. Is it likely that I just need to order a replacement kit and install a new one of these (to me it looks pretty bad, but I wondered if these other symptoms are consistent)? I found a video online that seems a good resource, but I just wanted a second opinion if this seems like the issue.
 
Attached Images  
Sponsored Links
  #2  
Old 02-04-18, 01:18 PM
Gunguy45's Avatar
Super Moderator
Join Date: Dec 2007
Location: USA
Posts: 21,119
Received 2 Votes on 2 Posts
Yep. you need a new gear kit. Don't cheap out and and only buy the single gear...get the whole kit.
 
  #3  
Old 02-04-18, 01:23 PM
Member
Join Date: Jan 2013
Location: U.S.A.
Posts: 2,079
Received 65 Votes on 60 Posts
Yes, that gear is intended to wear, or in an extreme case strip before anything more expensive goes. It's as likely as not that you're fine, but as long as your attention is on it raise and lower the door by hand. You should be able to do so with minimal effort, and it should stay when you stop moving it, whether raised, lowered, or midway. If not, your springs may need adjustment.
 
  #4  
Old 02-04-18, 05:31 PM
PJmax's Avatar
Group Moderator
Join Date: Oct 2012
Location: Northern NJ - USA
Posts: 54,245
Received 482 Votes on 452 Posts
The Liftmaster Gear Kit 41C4220A is pretty widely available.
Comes with instructions and is easy to install.
 
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread
 
Ask a Question
Question Title:
Description: