New posts
No new posts
Thread is closed
Hot thread with new posts
Hot thread with no new posts New posts No new posts Thread is closed Hot thread with new posts Hot thread with no new posts
DoItYourself.com Community Forums
>
Heating, Cooling, Air Conditioning, Ventilation and T-Stat Controls
>
Gas and Oil Home Heating Furnaces
New posts No new posts Thread is closed Hot thread with new posts Hot thread with no new posts
-
Hi all, I've been having issues with heating in my basement apartment for qui...
-
My heat pump compressor is fried, apparently due to a malfunctioning t-stat. I ...
-
Hi, I have a three zoned home: zone0 basement, zone1 first floor and zone2 sec...
-
Hello all, I am new to this forum and would just like to sa...
-
My Lennox Heat Pump (HP29-060-1P Elite 11 SEER 11.1 - installed May, 1998) air c...
-
Hello, I have 3 zones (1 for each floor). Everything worked fine up until 3 d...
-
Our Lennox heat pump compressor went bad. The unit is about 6 yrs. old. It was...
-
Greetings. After finding this forum yesterday and spending a few hours rummaging...
-
This will be the third compressor that weve had to replace in 8 months. When we...
-
I have a free standing natual gas furnace, with no heat ducks, that is vented. P...
-
16 replies
-
12 replies
-
11 replies
-
10 replies
-
13 replies
-
15 replies
-
9 replies
-
9 replies
-
8 replies
-
7 replies
DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact [email protected] Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2018 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.
