Lennox Help!!!!
#1
Member
Thread Starter
Join Date: Dec 2006
Posts: 3
Received 0 Votes
on
0 Posts
Lennox Help!!!!
Hi,
I have a Lennox 80UGH. It's blowing cold air. So I went to get a new ignitor and replaced it because:
1. I had a furnace guy replace the ignitor 2 years ago for the same problem.
2. Also the light blinks alternating. the manual says that means one of:
i) improper ground
ii) broken ignitor/open curcuit
iii) line voltage below 75 volts.
So after I replace the ignitor and power it up the ignitor glows for a few seconds and the thing shuts off??? And then repeats after a few minutes.
But still no flames/heat?
Please help!!!!!!!
I dont think its i) or iii) because we been using it for 7 years now and did not change any of those?
I have a Lennox 80UGH. It's blowing cold air. So I went to get a new ignitor and replaced it because:
1. I had a furnace guy replace the ignitor 2 years ago for the same problem.
2. Also the light blinks alternating. the manual says that means one of:
i) improper ground
ii) broken ignitor/open curcuit
iii) line voltage below 75 volts.
So after I replace the ignitor and power it up the ignitor glows for a few seconds and the thing shuts off??? And then repeats after a few minutes.
But still no flames/heat?
Please help!!!!!!!
I dont think its i) or iii) because we been using it for 7 years now and did not change any of those?