DoItYourself.com Community Forums > Heating, Cooling, Air Conditioning, Ventilation and T-Stat Controls > Gas and Oil Home Heating Furnaces

Salamander - torpedo kerosene heater

Thread Tools

Search this Thread

02-07-07, 02:14 PM

Blazer Jim

Member

Thread Starter

Join Date: Nov 2006

Posts: 53

Likes: 0

Received 0 Likes on 0 Posts

Salamander - torpedo kerosene heater

Hope this is the right spot for this. I have an old Sears branded 50,000btu "salamander" style portable heater that won't stay running. It starts up immediately and runs fine for about 1.5 - 2 minutes, then the restart button snaps out. It will start up again right away, but then shut off within seconds. It is getting fuel and the sparkplug used for igniting looks like new. Any ideas??

Thanks,

Jim

02-07-07, 02:32 PM

Ed Imeduc

Member

Join Date: Aug 2002

Location: Mountain Williams Missouri

Posts: 18,386

Likes: 0

Received 1 Like on 1 Post

Dont that one have a pump on it?? filter clean. You sure you have #1 water white oil??

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Gas and Oil Home Heating Furnaces
Furnace Cycling Cure?

S

swstar on Feb 07, 2007

Last night the furnace was running for about five minutes and then shutting off for five minutes and then beginning the cycle again. The thermostat was not showing a drop in temperature when the furnace would start. What do I need to check? Is it the thermostat or the furnace or somewhere in between. The furnace is about 25 years old and was last serviced/cleaned about six months ago. I don't know the particular model but it is a Lennox. The thermostat is a Honeywell digital programmable. Thanks
Gas and Oil Home Heating Furnaces
cleaning a FLAME PROVING ROD

H

hodag_ on Feb 07, 2007

My Amana Furnace, which is 4 years old, every winter without fail stops working. Everytime it is the FLAME PROVING ROD. It gets dusty and won't lite the furnace. My furnace repairman says all the new ones do this. I hate the damn thing, wishing I had my old pilot lite in the furnace. The furnace repairman says it is easy to clean this. Anyone know the step by step of cleaning a FLAME PROVING ROD. I would like to save a few bucks if it is easy to do. thanks.

Do Not Sell My Personal Information

Cookie Settings

DoItYourself.com®, founded in 1995, is the leading independent home improvement and repair website. We welcome your comments and suggestions. All information is provided "AS IS." Website operating problems contact webmaster@doityourself.com. Questions of a Do It Yourself nature should be submitted to our "DoItYourself.com Community Forums". Copyright© 1995-2022 MH Sub I, LLC dba Internet Brands. All rights reserved. You may freely link to this site, and use it for non-commercial use subject to our terms of use. View our Privacy Policy here.

Ask a Question