GE Iris Switch Work as Z-wave
#1
Member
Thread Starter
Join Date: Jan 2009
Location: PA
Posts: 124
Upvotes: 0
Received 0 Upvotes
on
0 Posts
GE Iris Switch Work as Z-wave
Got a GE 45639 "Iris" switch from Lowes. I was told it is basically a repacked GE Z-wave switch. However when I enroll it into my Honeywell Lynx Touch 5100 system, it sits forever on the "Device Found! Please wait..." Screen. Is this "Iris" technology different from Z-wave?
#3
According to the install manual the technology is the same.
I was trying to find out what the problem is with the Lynx.
Lowes - GE/IRIS - 45639
I was trying to find out what the problem is with the Lynx.
Lowes - GE/IRIS - 45639
#4
Member
Thread Starter
Join Date: Jan 2009
Location: PA
Posts: 124
Upvotes: 0
Received 0 Upvotes
on
0 Posts
That is what is confusing, the error. It finds the device but then sits at the please wait screen forever until I cancel it. Then it reports it as an error. I have tried it a few times and no luck.