Hey Everyone, New to the forum today and looks like there's some very knowledgeable people here. More than I can say about me when it comes to electronics. Here's my scenario. My 13 year old daughter wanted a big b-day party and I became the DJ for the night. I figured I would run my laptop into my 3 year old 850 receiver and play some downloaded MP3 (purchased) for the gang. I ran the connector cable from my headphone out jack and plugged the RCAs in the CD input jacks. It was working like a charm until I added some volume from the laptop. And then the newer 850 receiver went into Protect mode and that was that. Display worked fine but no sound. I had 15 minutes until the party and stressed out and pulled out my older D450Z Receiver and did it worked for awhile and then it blow. The display went blank and no sound. Here's what I figured happen. I overloaded the input jacks on both receivers. I didn't realize that I needed to have the volume on the receiver cranked up and not crank it up from the laptop. Can you tell me what to look for and what you think I may need to do to repair it. I work on cars all the time and I figure I can attack this one as well, with your help.. Thanks You in advance, Mark

Can anyone point me in the right direction with this Canadian model Mits, shuts off as soon as I turn it on, after a minute of shutting off it will stay on but vertical compression on the top 3"s, the bottom is a little bigger than normal with horizontal lines through it(about 2"s apart). Is this 45" Projection T.V. identical to the VS-4507R? Reason being, that is the only schematic diagram that I can get. Thanks, any advice is very much appreciated :cool: