Insulating Garage-vapor barrior needed?
#1
Member
Thread Starter
Join Date: Apr 2005
Location: USA
Posts: 112
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Insulating Garage-vapor barrior needed?
Hi and Thanks in advance for your time-
I am insulating an existing attached garage. The previous insulation was inferior, as it was installed in the 1950's, and was of low R value. I am installing R-13 in the exterior 2x4 walls, and R-19 in the 2x6 ceiling (all Kraft faced). The garage has a concrete floor. I will be using epoxy paint on the floor. Also- I will be installing electric radiant heat panels to keep the garage at around 45 degrees in the winter. There is no rot or moisture issue in the garage at present. My question is-do I need to install a polyethelene vapor barrier over the insulation, or do I just leave it without. Previously ther was no vapor barrier.This will be covered by 5/8" sheetrock.
Thanks.
Ray.
I am insulating an existing attached garage. The previous insulation was inferior, as it was installed in the 1950's, and was of low R value. I am installing R-13 in the exterior 2x4 walls, and R-19 in the 2x6 ceiling (all Kraft faced). The garage has a concrete floor. I will be using epoxy paint on the floor. Also- I will be installing electric radiant heat panels to keep the garage at around 45 degrees in the winter. There is no rot or moisture issue in the garage at present. My question is-do I need to install a polyethelene vapor barrier over the insulation, or do I just leave it without. Previously ther was no vapor barrier.This will be covered by 5/8" sheetrock.
Thanks.
Ray.
#4
Member
Join Date: Nov 2005
Location: USA
Posts: 2,338
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Depends on your climate. Polyethylene is highly impermeable. Only used in specific climates. Elsewhere, kraft facing is generally considered appropriate.
Check out http://www.buildingscience.com/resources/walls/Vapor_Barriers_Wall_Design.pdf
the site is a gold mine.
Check out http://www.buildingscience.com/resources/walls/Vapor_Barriers_Wall_Design.pdf
the site is a gold mine.
#5
Join Date: Aug 2002
Location: Mountain Williams Missouri
Posts: 17,505
Upvotes: 0
Received 1 Upvote
on
1 Post
Use a poly V/B over the paper. I dont care how hard you try you cant get a seal on the walls with just paper back insulation. We put it on the walls and over any door or windows. Then dry wall after done cut the door and windows out of it. Hey you got clean windows and doors.
ED
ED
#6
Member
Join Date: Jul 2005
Location: Ottawa, Canada
Posts: 814
Upvotes: 0
Received 0 Upvotes
on
0 Posts
Originally Posted by xiphias
Elsewhere, kraft facing is generally considered appropriate.
As Ed stated, it is impossible to get a good seal on the Kraft paper.
Originally Posted by xiphias
Check out http://www.buildingscience.com/resources/walls/Vapor_Barriers_Wall_Design.pdf
the site is a gold mine.
the site is a gold mine.