[b]Originally posted by Classicsat.[/b] with 4 switches, there are 16 possibilities. They would be 0000 0001 0010 0011 0100 0101 0110 0111 1000 1001 1010 1011 1100 1101 1110 1111 (easier just to give them for 16, than explain how binary works) Read more: [url]http://www.doityourself.com/forum/lighting-light-fixtures-ceiling-exhaust-fans/291651-setting-dip-switches.html#ixzz2aklOW8o5[/url]

Alright, let me describe the project. I am new to the forums so I hope that I don't mess anything up. House age: 1950 Overall Project: Existing room with no current use being converted to bar room Current status of project: Bar has been built in the room Current electrical in room: 4 wall outlets only, not controlled by any switches Current room features: Textured ceiling, smooth walls, crown molding Room location: First floor with two walls on exterior of room, no crawlspace above, basement directly below with access. Electrical panel is in basement directly below room. Current project: Install 4 pendant lights above bar and 3 recessed lights scattered about room to provide lighting in areas where its needed Problem: I have no idea where to begin I am a relatively new home owner. I like to do things where I can, mostly because I like to learn new things. I am a mechanical engineer by trade so I understand concepts fairly easily, the how-to is the part that I struggle with. So reading above, I am looking for the best way to wire this project. I've gotten suggestions ranging from removing the whole ceiling to cut a hole in the ceiling and see what I've got. I'd rather not go with a plan of action that starts with, cut it open and see what you're working with. I have access to most tools through collection of family members so that is not a problem. I have never wired anything to this extent before. I'd prefer that "pay someone else to do it" is not the option being suggested, as that is always plan B.