I bought and hung a new light fixture in a bedroom (a little chandelier), and everything was fine. it worked fine, everything else was still working fine. Then i changed out the 5 receptables and the 1 light switch in the bedroom. i changed them out because they were an almond off white color and i wanted a plain white look. so i replaced them with new white ones. after doing so, the bedroom chandelier still worked with the one light switch that controls it, but the hallway light that is on the same circuit as the bedroom light and receptables is not working. it is not turning on. it was two switches that control it. one at either end of the hallway.

Two questions: I have two sets of Craftsman halogen work lights. One is a twin unit and uses 500 watt or less halogen bulbs. I know I can insert a LED and it will work. I plan on keeping one side as Halogen (extra bright along with heat if needed) the other side with an equivalent 300 watt T-3 LED. But is there a 500 watt equivalent LED I can use? What is the brightest LED T-3 replacement? [img]https://cimg2.ibsrv.net/gimg/www.doityourselft.com-vbulletin/2000x1124/img_20210304_145639961_c3a7806cbec966d475769ee6577ca07071beb030.jpg[/img] [img]https://cimg4.ibsrv.net/gimg/www.doityourselft.com-vbulletin/2000x1124/img_20210304_145612729_423d79bf4734b5c8f765b55e85c1a57dccef553d.jpg[/img] The second work light is a single halogen Craftsman model 9.83991 and uses a two bulb configuration to allow 150/300/500 watt brightness as you push the switch. Can I use a LED in this unit? Will I need to replace both bulbs and will I get the three levels (or at least two levels) of brightness? Can I mix LED and halogen? [img]https://cimg1.ibsrv.net/gimg/www.doityourselft.com-vbulletin/2000x1124/img_20210304_145659615_fa55696c1e8086241a525eda1fd116a6c8d833cd.jpg[/img]