Welcome to the DoItYourself Forums!

To post questions, help other DIYers and reduce advertising (like the one on your left), join our DIY community. It's free!

Chainsaw Problem


Keith's Avatar
Visiting Guest

Posts: n/a

06-30-03, 08:25 PM   #1  
Keith
Chainsaw has a cold

I have an old Olympyk chain saw that runs good until it warms up.Then it wont come up to full power.If your run a tank of gas through it and then try to refill,when the gas cap comes off there is alot of pressure in the tank.After the fuel is full,the tank looks like it has an Alka-Seltzer in it.Lotsa bubbles. Also the air filter is damp.......I'm thinking rings are bad but............any ideas?

 
Sponsored Links
cheese's Avatar
Forum Topic Moderator

Join Date: Jul 2001
Posts: 16,567
GA

07-01-03, 09:07 AM   #2  
Hello Keith!

I'm not real familiar with Olympyk saws, but many saws pressurize the tank. It sounds to me like you may have carburetor problems, but check the compression before getting too involved.


"Who is John Galt?" - Ayn Rand (Atlas Shrugged)

God bless!

 
Search this Thread